977
edits
Changes
JST JGD-125C Water Cooled Spindle (view source)
Revision as of 06:50, 4 May 2022
, 06:50, 4 May 2022added more O-ring notes
=== O-rings ===
=== O-rings ===
The top cap with the water inlets have 10mm OD 1mm deep recesses with a 6mm ID hole for O-rings. Maybe one of these?:
* [https://www.mcmaster.com/1171N144/ Square-Profile Oil-Resistant Buna-N O-Ring, 1.5 mm Wide, 7 mm ID | McMaster-Carr]
* [https://www.mcmaster.com/1171N144/ Square-Profile Oil-Resistant Buna-N O-Ring, 1.5 mm Wide, 7 mm ID | McMaster-Carr]
* [https://www.mcmaster.com/1302N037/ Oil-Resistant Buna-N O-Ring, 1.8 mm Wide, 6 mm ID | McMaster-Carr]
* [https://www.mcmaster.com/1302N037/ Oil-Resistant Buna-N O-Ring, 1.8 mm Wide, 6 mm ID | McMaster-Carr]
* [https://www.mcmaster.com/9262K166/ Oil-Resistant Buna-N O-Ring, 2 mm Wide, 6 mm ID | McMaster-Carr]
* [https://www.mcmaster.com/9262K166/ Oil-Resistant Buna-N O-Ring, 2 mm Wide, 6 mm ID | McMaster-Carr]
The bearing housing portion of the spindle has 8mm OD 1mm? deep recesses with 4mm? ID holes for O-rings.
=== Fasteners ===
=== Fasteners ===